There are 3 different types for MK8 (20X20X10) mm, including Copper cover for holding NTC 3950 100K thermistor , lock for Heater cartridge on side and lock for Heater cartridge on top. For 3D printers and other applications that require accurate temperature sensing and control, Copper cover for holding thermistor can keep the temperature detector stable and accuurate.
Also, you can choose the location of the 3D printing block to be either on the top or on the side depending on your 3D printer setup. f you have a 3D printer that is setup with an extruder in the front and a heated bed at the back, for example, you might want to install the lock on the top. If you have a 3D printer that is setup with a heated bed in the front and an extruder in the back, for example, you might want to install the lock on the side.
Size: 20mm (Long) X 20mm (Width) X 10mm (Height)
Supported Heat Cartridge: M6 X 20mm
Supported Thermistor: NTC 3950 100K
Quantity: 1 heating block
The product in this page is only for illustration purpose, not the real product. Actual product vary due to product enhancement.
►Keep away from small children.
►This products are only suitable for 3D printer use indoors.
►To ensure your safety and proper operation of the equipment, we recommend that you should fully understand the operation and safety features of the 3D printer.
►Don't put this item into your month.
►3D printer replacement parts, Always shut off power to the circuit before starting installation work.
►The surface temperature of the 3D printer might be high, and be careful not to touch the heating element to prevent injury.
►3D printer initial operation, Do not run the equipment Unattended state.
►When printing with a PLA(190°C-230°C) or ABS(230°C-250°C)consumable, if the temperature sensor and other accessories fail, it may cause high temperature hazards. Do not run the equipment Unattended state.
►To ensure the users will use the product safely and properly, please read your 3D printer manual first and follow the instructions step by step before using the product.
►Due to the variety of possible end-uses, it is ultimately the responsibility of the customer to determine a product's suitability for a particular application.