This listing is for 1 X Cartridge Heater to suit various models of 3D printer head.
Voltage: 12V (Voltage)
Power: 50W (Watt)
Wire Length: 1M of White heat resistant cable
Material: Stainless Steel
Heating temperature: up to 350 degrees
►Keep away from small children.
►This products are only suitable for 3D printer use indoors.
►To ensure your safety and proper operation of the equipment, we recommend that you should fully understand the operation and safety features of the 3D printer.
►Please read your use guideline of the 3D printer manual carefully before installing and using it: <3D printer consumable: PLA (190°C-230°C) or ABS (230°C-250°C)>
►3D printer replacement parts, Always shut off power to the circuit before starting installation work.
►The surface temperature of the 3D printer might be high, and be careful not to touch the heating element to prevent injury.
►3D printer initial operation, Do not run the equipment Unattended state.
►When printing with a PLA(190°C-230°C) or ABS(230°C-250°C)consumable, if the temperature sensor and other accessories fail, it may cause high temperature hazards. Do not run the equipment Unattended state.
►To ensure the users will use the product safely and properly, Please read your 3D printer manual first and follow the instructions step by step before using the product.
►Due to the variety of possible end-uses, it is ultimately the responsibility of the customer to determine a product's suitability for a particular application.
►The effective heating part of the heater must keep dry.
►The electrical connector of the single-ended heater should be placed out of the insulation layer and heating room, and the working voltage shall not exceed its rated value of 10%. The shell should be effectively grounded.
►Electric components working environment, the temperature should not be greater than 95 degrees, no explosive or corrosive gases.
►Electric components should be stored in a dry place.